MOTOGADGET MO.FLASH

mo.flash digital flasher

• Ultra-small and light, practically just a piece of cable with a tiny device no bigger than a sweet
• Ideal for custom bikes and conversions with limited space - no bulky standard flasher relay
• Can be installed, for instance, in the handlebar, frame tube or wiring harness
• Entirely load-independent - always constant and correct flashing frequency
• Suitable for all LED turn signals, micro turn signals, 10 W turn signals, 21 W turn signals etc.
• No resistors or other accessories are necessary
• Functions with 4 turn signals or 2 bar-end turn signal etc.
• Immediate, lossless turn signal activation
• Super-easy connection using just two cables - simply connect in series
• Absolutely waterproof
• Short-circuit proof
• Automatic overload protection
• Protection against voltage spikes from the vehicle's electrical system
• Operating voltage: 5-18 V, therefore also suitable for 6 V turn signals
• Dimensions (LxWxH): 18x13x9.5 mm; length of connecting cable: 2x50 mm; weight: approx. 4 g

• Note: If your motorcycle only has one turn signal indicator, or if an acoustic turn signal monitor has been retrofitted, technical knowledge is required for installing the flasher unit, and we recommend that the Kellermann flasher (Order no. 10032036) is used.
• As an alternative, you can use a resistor for each LED turn signal. If you wish to replace 4 x 21 W original turn signals with 1-2 W LED turn signals, you should install 4 resistors, Order no. 10032063.

• Important! Not suitable for use with hazard warning lamp systems!